Compatibles devices:
RUT devices
TRB devices
RUTX devices
...
RMS is using MQTT and the connection is secured with X.509.TLS1.2 and also compatible with standard TLS1.3
Comparison table
With RMS | Without RMS |
|---|---|
Remote Works | Expense labor costs |
Access 3rd party device without additional expenses | Additional software systems costs |
Multi-configuration, settings change to all devices at once | Time wasted, manually updating firmware |
Control non Teltonika devices (any equipment with Web UI) | / |
Position of each device (Geo view and access) | / |
No public IP needed | / |
Stay in control with your devices remotely (logs, FOTA..) | / |
Different versions of RMS
...
https://wiki.teltonika-networks.com/view/Teltonika-id
Note
Please use support@mirifica EU contact us to send us a request for any technical support.
...
Always make sure to use different subnets for LAN and RMS VPN networks, since the RMS VPN uses OpenVPN TUN Layer 3 connection. For example, as done during the remote desktop session, you could use the 192.168.2.0 network for the router's LAN and set the 192.168.255.0 as the RMS VPN virtual network.
Make sure that the RUT955 and your other VPN clients are connected to the RMS VPN Hub. You can check this in the "General" tab under the "Sessions" window.
When adding routes, make sure to use a the correct size subnet mask. For example, if you are adding a route to a specific IP address, the netmask should be set to 255.255.255.255
Try using the OpenVPN Connect client if you have any connectivity issues to with the RMS VPN Hub on Windows.
Make sure to set a Gateway IP address on the Terminal device (the Gateway IP address should be the same as RUT955 LAN IP address)
...
FAQ
Q: Can we run RMS on a separate server?
A: Yes, You can run RMS on a separate server, RMS has a local version which can be run on a separate server.
...
A: The license is valid for 30 days for one supported device.
--
Q: How to enable/disable “auto-extend”?
A: to enable/disable the "auto-extend" option, please follow these steps:
navigate to Administration - Companies;
from the list of companies, found the required company and click
in a new window, under the tab "Devices" will be an option to control "auto-extend
--
Q: How to have more information about used credits, how many left, get history?
A: You can see the remaining amount of credit by going to Administration -> Companies. Select the desired company and then go to Resource history. There you can see when credits were added and how many credits are left. You can also see when and which device has used up the credit after downloading the PDF file.