This advantageous indoor positioning system for the location of people and short-range objects is suitable for many industrial applications such as the safety of isolated workers, vehicle access control or the location of logistics equipment in a warehouse.
Beacons should be placed with the minimum signal disrupt, this will higher the chance to get information from them. They need to be configured with the application “device manager mobile“ When you are getting beacons, they are always being OFF till you enable it. Other valuable configuration set is with which protocol it should work (Beacon or Eddystone) because on basic configuration on beacons is setup Id, from which device won‘t get any information. We would recommend to make higher signal strength. Max is 4dB.
Device is getting a signal from the beacon in every scan and all data which was found and used for beacon will be shown in data packet or configurator.
It would be better if when you are making a setup you would place it where you will get less signal corruption by obstacles.
Obstacles could be different but BLE should work about 50 meters maximum in the case we have a lot of interference.
To optimize communication, in configuration mainly should be enabled CODEC 8 Extended and we would recommend to use maximum signal strenght of BT from device side too. In beacon list you can use filter for them. Then only those beacons which is filtrated will be found in that building.
Functioning
Beacons (BLE ID TAGS) transmit signal which devices is catching them and getting information:
First half byte – current data part
Second half byte – total number of data parts
Bitwise parameter, specify BLE beacon type and parameters
(signifies if specific data is present for certain beacon)
Bit 0 – signal strength 0/1
Bit 1 – Battery Voltage 0/1
Bit 2 – Temperature 0/1
Bit 3 – Reserved
Bit 4 – Reserved
Bit 5 – BLE beacon type 0/1
Bit 6 – Reserved
Bit 7 – Reserved (eddystone/ibeacon)
iBeacon – 20B (UUDI, major, minor)
Eddystone – 16B
(Namespace, Instance ID)
For the configuration of the gps-tracker-beacon and the configuration on the server to obtain information in real time, all information from beacons comes via AVL ID385. On the link below, you can find all necessary information about how to parse this data.
To manage and configure beacon via applications, the phone must have an NFC and BT reader.
Teltonika vehicle tracker supports up to 100 beacons at a time.
https://teltonika-gps.com/downloads/en/blue-coin-id/Sensor-and-Beacon-testing-instructions-v1.2.pdf
0 Comments