...
Comparison Table
Features | Blue Coin | Blue Puck |
|---|---|---|
| up to 200 meters (open field) | up to 500 meters (open field) |
| up to 5 years | up to 20 years |
| smaller | larger |
| lighter | heavier |
You can have more information on:
https://teltonika-gps.com/products/accessories/
BLE connection with FM devices
In the first step you need to activate your BLE sensor via NFC Application => Device Manager Mobile
Then read the instructions- Section- BLE sensors testing instructions , page 7
https://teltonika-gps.com/downloads/en/blue-coin-mag/Sensor-and-Beacon-testing-instructions-v1.2.pdf
Next
https://wiki.teltonika-gps.com/view/FMB120_Bluetooth_4.0_settings
Adding information:
Please check the link about Bluetooth 4.0: https://wiki.teltonika-gps.com/view/FMB003_Bluetooth_4.0_settings
Remember that you must activate these parameters in the device configuration => I / O section
Then, after pairing, you will receive the appropriate AVLID on your server.
Note: If the Manufacturer Data Mode is activated, You should modify it using Device Manager Mobile to change this parameter.
...
FAQ
Q: From which firmware can blue coin accessories be used?
A: From base 03.25.13.rev.00
--
Q: Is the beacon compatible with all FMBXXX devices?
A: Beacon/BLE sensors Firmware versions is compatable for all FMBXXX devices (expect FMB630 and FMB640) for FM3001, FMT100.
--
Q: How many sensors/beacons can we connect at the same time with fleet management?
A: Up to 4 Sensors at once, Up to 100 Beacons at once.
Q: where is the difference between Eventual and Periodic?
A: In Beacon list settings, configure Beacon Detection as "All" and Beacon Record as "Eventual". This will detect all surrounding Beacons and create Beacon records every 30 seconds.
Periodic mode creates an additional repeatable record (more than 30 s) - other / greater than the Update frquency
Thus, the Update Frequency settings where the minimum time is 30 seconds are important.